The IF30 incubator is ideal for all aplications with temperatures up to 80°C , specifically for incubating living cultures at 37° C. Thanks to the finely-tuned control technology, critical temperature overshoots are completely ruled out, valuable loads are therefore warmed up particularly carefully.
Ventilation and Control
• natural convection
• adjustment of pre-heated fresh air admixture by air flap control in 10% steps
• vent connection with restrictor flap
• adaptive multifunctional digital PID-microprocessor controller with high-definition
TFT-color display
• self diagnostics for fault analysis
• 1 Pt100 sensor DIN class A in 4-wire-circuit
• digital backwards counter with target time setting, adjustable from 1 minute to 99 days
• parameters adjustable on ControlCOCKPIΤ: temperature, air flap position, programme time, time zones, summertime/wintertime
• setpointWAIT function – the process time does not start until the set temperature is reached
• resolution of display for setpoint values 0.1°C up to 99.9°C, 0.5°C from 100°C and for actual values 0.1°C
• programme stored in case of power failure
• including works calibration certificate for 37°C
• overtemperature protection (double)
• resolution of display for setpoint and actual temperature values 0,1°C
• calibration facility directly at ControlCOCKPIT for three freely selectable temperature values.
Textured Stainless Steel Casing
• w x h x d: 585x704x434
• fully insulated stainless stell door with
2-point locking
• rear zinc plated steel
Interior-Heating Concept
• wxhxd: 400 x 320 x 250 mm, 32lit
• easy to clean interior, made of stainless steel, reinforced by deep drawn ribbinng with integrated and protected large-area heating on four sides
• 1 stainless steel grid
• inner glass door
Temperature range
• min 5°C above ambient up to 80°C
Voltage/Power Rating
• 230v(+/-10%), 50Hz / approx. 1600W